Fadini Safety Edge for Sliding and Swing Gates up to 1.5 m

Fadini Safety Edge for Gate Automation up to 1500 mm

The Fadini F/2076L is a safety edge available in 1000 mm and 1500 mm sizes, designed for crush and trap protection on sliding and swinging gate automation systems. Fitted to the leading edge of a moving gate, the safety edge detects contact along its entire height and signals the control unit to reverse or stop the gate.

Suitable for residential gated estates, apartment block entrances and commercial premises, this safety edge achieves EN12978 compliance when used with the Fadini Elpro series electronic control unit, subject to control testing. The clip-mounted installation system includes a cardboard template for accurate fixing, and the rubber edge can be cut to a custom height provided it remains 40 mm longer than the aluminium profile.

Key Features

• Available in 1000 mm and 1500 mm sizes
• Full-height detection along the entire edge length
• TPE soft extruded rubber with aluminium hard extruded profile
• Selectable NC or resistive (8.2 KOhm) contact output via J1 jumper
• Pre-tensioned steel cable with adjustable sensitivity
• Automatic reset after alarm - no manual reset required
• Clip-mounted installation with cardboard template supplied
• Can be cut to custom height

Technical Specifications

• Available sizes: 1000 mm, 1500 mm
• Pre-run: 18 mm
• After-run: 24 mm
• Maximum bearing speed: 12 m/min
• Response time at 12 m/min: greater than 0.15 s
• Response time at 0.6 m/min: greater than 2 s
• Distortion recovery time: less than 2 s
• Contact output: NC or Resistive (8.2 KOhm) via J1 jumper
• Operating temperature: -10 degrees C to +60 degrees C
• Relative humidity: 93% at 40 degrees C
• Protection class: IP54
• Safety category: 2/3 EN954-1 (with Elpro series control)
• Materials: TPE soft extruded, aluminium hard extruded, nylon parts
• Certification: EN12978
• Maintenance interval: periodic check every 6 months recommended