Fermax DUOX PLUS Floor Decoder/Isolator with 10 Outputs

Fermax 9419 DUOX PLUS Decoder/Isolator

Decoder 10 outputs, 1 output / dwelling and max. 1 terminal / home. Advantages: 1) Longer derivation distance; 2) Isolates terminals against short circuit; 3) Programming the terminals without entering the home; 4) Monitor Installer Menu Lock.

Key Features:

Longer derivation distance. 10-outlet floor decoder. One output for each home, allowing a maximum of one terminal (monitor / telephone) per home. Multiple decoders can be installed on each floor. Each outlet allows to increase the diversion distances in floor up to 100 m.

Isolation between terminals. Isolation from load and signal reflections. If a short circuit or overconsumption is detected in an output, said output is isolated from the rest of the installation (both the DUOX PLUS bus and the rest of the outputs will continue to operate normally).

Remote programming of the terminals (without entering the home). It is not necessary to enter the dwellings to program the address of the terminals since the decoder includes a group of microswitches (dipswitches) to program the addresses of each of its outputs.

Lock / Unlock monitor installer menu (only available for V42.18 or higher monitors). After performing remote terminal programming, the decoder locks the Installer Menu on the monitors. In this way, it is no longer possible to access the Installer Menu from the monitor (by pressing F1 + Lock release) preventing the user from modifying installer parameters such as the terminal address. It is possible to Unlock the installer menu: that way from the monitor you can already access this menu. After 30 minutes it locks up again.

Technical Specifications:

• The assembly can be carried out both by screw fixing and by installation on a DIN rail
• Dimensions: DIN 10 rail
• Supply voltage: 24 Vdc
• Idle consumption: 828 mW
• Maximum consumption: 864 mW

Dimensions:

• 90 x 175 x 37 (hwd mm)