Fadini ELPRO 7 RP Control Panel for NUPI 66 Swing Gate Operator

Fadini 6610L ELPRO 7 RP Control Unit for NUPI 66 Swing Gate Operator

The Fadini ELPRO 7 RP is the electronic control unit for the NUPI 66 swing gate operator. It suits installers and homeowners who want a no-nonsense swing gate controller with one-button programming and torque control to keep the gate moving with the right force.

The board provides an electric lock power supply, a radio card plug-in connector, connections for photocells and open-stop-close push buttons, green/red diagnostic LEDs, low and high voltage fuses and storage of time settings. Operating modes include automatic, semiautomatic, step-by-step automatic, pedestrian and pre-flashing. Motor run time is approximately 20 s, with a 15 s dwell time on automatic (max 90 s) and a 6 s gate delay on closing. It is housed in a 210 x 295 x 110 mm IP64 box.

Choose the ELPRO 7 RP to get your NUPI 66 gates working dependably.

Key Features

• Operating modes: automatic, semiautomatic, step-by-step automatic, pedestrian, pre-flashing
• One-button programming
• Torque control
• Electric lock power supply
• Radio card plug-in connector
• Connections for photocells and open-stop-close push buttons
• Green/red diagnostic LEDs
• Low and high voltage fuses
• Storage of time settings

Technical Specifications

• Part Number: 6610L
• Compatible with: Fadini NUPI 66 swing gate operator
• Single-phase supply: 230 Vac, 50 Hz
• Motor max. power: 500 W
• Photocells/keyswitch/receiver output: 24 Vdc, 500 mA
• Pilot light output: 24 V, 3 W
• Flashing light output: 230 Vac, 25 W
• Motor run time: approx. 20 s
• Dwell time: 15 s on automatic, max 90 s
• Gate delay on closing: 6 s
• Box dimensions: 210 x 295 x 110 mm
• Protection grade: IP64
• Working temperature: -20 ¡C to +55 ¡C