Bticino 3501/8 Configurator 8 Pack of 10 - 2 Wire System

Bticino 3501/8 Configurator Number 8 for addressing devices on the Bticino 2 Wire SCS BUS door entry system. Supplied in a pack of 10 pieces. Used to assign unique addresses to handsets, monitors, entrance panels and system accessories.

Each configurator is inserted into the addressing socket on the rear of the device using a small flat-blade screwdriver. Configurators are numbered 0 to 9 and combined across multiple socket positions to set the full device address. Entrance panels use addresses 0-95 (P address) and internal units use addresses 0-99 (N address). Ensure the correct address is set before powering the system.

About This Product

The Bticino 3501/8 is a physical plug-in configurator numbered 8, used to set device addresses on the Bticino 2 Wire SCS door entry system. It is essential for commissioning any system using physical configuration rather than software-based setup. Installers will need a selection of configurators numbered 0-9 to address all devices on site.

Key Features

• Configurator value: 8
• Pack of 10 pieces
• Plug-in physical configurator for SCS BUS addressing
• Compatible with all Bticino 2 Wire SCS devices with configurator sockets
• Used for entrance panel, internal unit, actuator and interface addressing
• Simple insertion with flat-blade screwdriver

Technical Specifications

• Configurator Number: 8
• Quantity per Pack: 10
• System Compatibility: Bticino 2 Wire SCS BUS
• Configuration Type: Physical plug-in

Common Questions

• How are addresses set? Configurators numbered 0-9 are inserted into socket positions on the device to build the full address. For example, an internal unit addressed as 28 would use a 2 configurator in the tens position and an 8 configurator in the units position.
• Can these be reused? Yes, configurators can be removed and reinserted as needed during commissioning.

Compatibility

Compatible with all Bticino 2 Wire SCS BUS devices featuring physical configurator sockets, including Sfera entrance panels, Classe 100 and Classe 300 internal units, Sprint L2 handsets, DIN-rail actuators and system interfaces.