AES E-LOOP Inground Commercial Loop Kit EXIT MODE with LCD Transceiver

AES EL00IG-KLT E-LOOP Inground Commercial Loop Kit EXIT MODE with LCD Transceiver

The Inground Wireless Vehicle Detection System uses magnetometer sensors to detect the presence and movement of vehicles. These detections are transmitted to a nearby transceiver for gate activation. The sensors are installed in the ground of entry or exit passages using sikaflex, contain a replaceable Lithium battery, and can withstand almost any vehicle.

Note: Gate or door controller must have a dedicated open input and auto close function enabled.

Both e-loop models are available in two modes: PRESENCE MODE WITH ADDED RADAR PROTECTION OR EXIT MODE.

Installation in 3 simple steps:

• 1. Code in the e-Loop
• 2. Core bore 89mm hole 70mm deep and secure using flexible mastic (3.5" hole 2.5"Ñ2.7" deep)
• 3. Calibrate the e-Loop... and youÕre ready to operate in less than 30 minutes

This Kit Includes:

• 1 x e-Loop Inground Exit mode
• 1 x e-Trans 200 (transceiver)
• 1 x Magnet

Features:

• Fast and simple installation (quick non-permanent installation)
• Not effected by ground movement
• Range up to 50 metres/yards
• Exit Mode
• Commercial Inground E-loop Flush Mounted
• Lower power consumption: 3-axis magnetometer for vehicle detection
• Compact design
• Compatible with various gates
• Reliable radio communications with transceiver

Technical Specifications:

• 8 Hz sampling rate
• Auto-calibration
• Exit/Entry detection mode
• 14500 mA battery (included) giving up to 6-10 years of battery life (depending on mode)
• Top access for changing the battery
• High security 128-bit encryption
• IP rating: IP68

Dimensions:

• Recesses into the driveway Ñ 55mm inground height x 89mm diameter.